[Type text] Planar Simplicity Series RS232 PROTOCOL Document 020-1244-00 Rev A
3.4 Power state at Cold Start Command is used to set the cold start power state, the cold start power state are updated and stored by this comman
4. MESSAGES - INPUT SOURCES 4.1 Input Source This command is used to change the current input source. 4.1.1 Message-Set Bytes Bytes Descript
Example: Set on DVI-D with Source label displaying on OSD (Display address 01) Header Monitor ID Category Code0 Code1 Length Data Control Data[0] D
Header Monitor ID Category Page Length Control Data[0] Data[1] Data[2] Checksum 0x21 0x01 0x00 0x00 0x05 0x01 0xAD 0xFD 0x0A 0x7E
4.3 Auto Signal Detecting 4.3.1 Message-Get Bytes Bytes Description Bits Description DATA[0] 0xAF = Auto Signal Detecting – Get Command r
5. MESSAGES - VIDEO 5.1 Video Parameters The following commands are used to get/set video parameters as it is defined below. 5.1.1 Message-
DATA[5] Tint (Hue) -50 to 50(0x0 ~ 0x64) of the user selectable range of the display. Example: Set all video parameters to 0x37 (55 %) (Display
Bit 3..0 Picture Format. 0x00 = 4:3 0x01 = Custom 0x02 = Unscaled 0x03 = Wide Screen 0x04 = Movie expand 16:9 0x05 = Auto The display shall resp
6. MESSAGES - AUDIO 6.1 Volume This command is used to set/get the Volume as it is defined as below. 6.1.1 Message-Get Bytes Bytes Descript
6.2 Volume Limits This command is used to set the volume limit (minimum, maximum and switch on volume). 6.2.1 Message-Set Bytes Bytes Desc
1. INTRODUCTION 1.1 Purpose The purpose of this document is to explain in detail the commands and steps that can be used to con
7.1 Audio Parameters This command is used to set/get the audio parameters as it is defined as below. 7.1.1 Message-Get Bytes Bytes Descriptio
8. MISCELLANEOUS 8.1 Operating Hours The command is used to record the working hours of the display. 8.1.1 Message-Get Bytes Bytes Descript
Example: (Display address 01) Header Monitor ID Category Code0 Code1 Length Data Control Data[0] Data[1] Data[2] Checksum 0xA6 0x01 0x00 0x00 0x
8.3 Serial Code 8.3.1 Message-Get Bytes Bytes Description Bits Description DATA[0] 0x15 = Serial Code Get Command requests the display t
9. Command summary Command name Set Command Get Command Command Code Remarks Communication Control √ √ 0x00 Generic report Platform and version l
frame GND Note: A crossover cable (null modem) is needed for connection to the host controller: Digital Signage displays use RXD, TXD and GND p
2.3 Command Format The RS232 packet format: Header Monitor ID Category Code0 Code1 Length Data Control Data[0] … Data[N] Checksum In detail: Nu
MESSAGES - SYSTEM 2.4 Communication Control This defines the feedback command from monitor to host controller when it receives the
3. MESSAGES - GENERAL 3.1 Platform and Version Labels This command provides the model name of platform and the display Software version to the h
3.2 Power state This command is used to set/get the power state as it is defined as below. 3.2.1 Message-Get Bytes Bytes Description Bi
3.3 User Input Control The following commands are used to lock/unlock the Remote Control and the Local Keyboard functionality corresp
Commentaires sur ces manuels