Simplicity Synergy X9 Spécifications télécharger pdf (Page 240)

100

101

Synergy Nano Technical Manual, Revision -

Page 240

14.3 Using Cascade Mode

14.3.1 Enable Cascade Mode

To enable Cascade mode, press the SETUP Screen Navigation Key and proceed to the Enabled folder

shown below (PID Settings\PID Ch 1\Cascade\Enabled)

Change the Enabled item’s value to Enabled

(Disabled is the default value).

14.3.2 Maintenance \ Channel PIDs Screen

The Channel PIDs screen shows a third column when cascade mode is enabled for the channel. All columns

show values for the following parameters: Pn, In, Dn, PID, Err, Setpoint, Actual, P.B., Reset and Rate.

The Setpoint and Actual numbers in the cascade

column are the desired setpoint, and actual

temperature of the product inside the chamber.

♦ Setpoint & Actual values under Heating and Cooling is the air temperature.

♦ Setpoint value under Heating and Cooling is the calculated air temperature setpoint from the Cascade

PID loop.

♦ Cascade PID parameters: Pn, In, Dn, PID values range from -100 to +100%.

Note: -100% corresponds to the Cascade Low Limit temperature

Note: +100% corresponds to the Cascade High Limit temperature

♦ The values in the Heating & Cooling columns range from 0 to 100%

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 351 352

Commentaires sur ces manuels

Pas de commentaire

Simplicity Synergy X9 Spécifications Page 240

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs Simplicity Synergy X9