Simplicity 9518 Series Manuel d'instructions

Page 1 of 16 0901052 Rev: H (05/13) Micro-Pro II MP-200 / 300 Series Instruction Manual

0901052 Rev: H (05/13) Page 10 of 16 WIRING DIAGRAM (SINGLE TRANSFORMER)

Page 11 of 16 0901052 Rev: H (05/13) WIRING DIAGRAM (TWO TRANSFORMER)

0901052 Rev: H (05/13) Page 12 of 16 ASSEMBLY DIAGRAM (SINGLE TRANSFORMER)

Page 13 of 16 0901052 Rev: H (05/13) ASSEMBLY DIAGRAM (TWO TRANSFORMER)

0901052 Rev: H (05/13) Page 14 of 16

Page 15 of 16 0901052 Rev: H (05/13)

0901052 Rev: H (05/13) Page 16 of 16 DISCLAIMER Knight LLC does not accept responsibility for the mishandling, misuse, or non-performance of the descr

0901052 Rev: H (05/13) Page 2 of 16 TABLE OF CONTENTS Introduction ...

Page 3 of 16 0901052 Rev: H (05/13) INTRODUCTION Micro-Pro II warewash systems provide the versatility of probe or probeless detergent control through

0901052 Rev: H (05/13) Page 4 of 16 INSTALLATION Mount the unit on a nearby wall (using suitable hardware) or on top of the dishwasher if desired. Try

Page 5 of 16 0901052 Rev: H (05/13) PROBE INSTALLATION (if required) (1) Install the probe in the wash tank below the water level. It should be away

0901052 Rev: H (05/13) Page 6 of 16 RINSE OPERATION The rinse pump will operate whenever the rinse transformer is energized (if so equipped) or when a

Page 7 of 16 0901052 Rev: H (05/13) SANITIZER OPERATION A selector switch sets the sanitizer pump to operate with detergent feed, or with rinse feed.

0901052 Rev: H (05/13) Page 8 of 16 PROBE OPERATION  With the detergent power ―on‖, the conductivity probe senses detergent concentration. When conc

Page 9 of 16 0901052 Rev: H (05/13) PROBELESS OPERATION  Controls detergent concentration without a probe, based on timed detergent feed.  Initial